scpcsc_feed completes MultiConf

scpcsc_feed is a command-line utility for Windows which is a companion-tool for MultiConf in case you need to configure numerous SpringCard PC/SC couplers in batch mode, or change the settings quickly without a needing a full-featured GUI.

scpcsc_feed is available at Just unzip the archive in the folder you want, and open a command prompt (cmd.exe) in this folder to use the tool from the command line.

Connect a SpringCard PC/SC coupler to your computer, and invoke scpsc_feed without any parameter to see the integrated help:

SpringCard -- scpcsc_feed
Read/write data in the non-volatile memory of a SpringCard PC/SC Reader

Build : Apr 15 2015
Copyright (c) 2010-2013 Pro Active SAS, France
Go to for information and updates.

Connected through PC/SC.
Connected, device : SpringCard Prox'N'Roll HSP 2.00 [1]
Firmware features : 0073232F

Usage: scpcsc_feed -d            dump configuration registers
scpcsc_feed -r XX         show value of register XX
scpcsc_feed -s XX=YYYY... write register XX with value YYYY...
scpcsc_feed -e            erase all configuration registers
scpcsc_feed -sf FILE      write register(s) from config FILE
scpcsc_feed -t XX=YYYY... set temporarily register XX with value YYYY...
scpcsc_feed -tf FILE      set temporarily register(s) from config FILE


A few interesting commands

Read-back the current configuration

scpcsc_feed -d

Restore the factory configuration (blank all registers)

scpcsc_feed -e

Apply the configuration from a MultiConf project

scpcsc_feed -sf [file.multiconf]